Bromoxynil plus MCPA

Bromoxynil plus MCPA

1 Trade name	Manufacturer	Form
AMGROW CHEMSPRAY WEED CONTROL BIN-DIE SELECTIVE LAWN WEEDER	ENVIROGREEN PTY LTD	EC
AMGROW SIR WALTER BUFFALO LAWN WEED CONTROL	ENVIROGREEN PTY LTD	EC
BARMAC BINDII KILLER SELECTIVE WEEDKILLER	BARMAC INDUSTRIES PTY LTD	EC
BUCTRIL MA SELECTIVE HERBICIDE	BAYER CROPSCIENCE PTY LTD	EC
CHEMAG BROMOX MA SELECTIVE HERBICIDE	IMTRADE AUSTRALIA PTY LTD	EC
FARMOZ BRONCO MA SELECTIVE HERBICIDE	FARMOZ PTY LIMITED	EC
NUFARM BROMICIDE MA SELECTIVE HERBICIDE	NUFARM AUSTRALIA LIMITED	EC
PAUL MUNN THE LAWN SPECIALIST B6 BINDII & CLOVER SELECTIVE LAWN HERBICIDE	PAUL MUNN'S GARDEN CENTRE PTY LTD	EC
RICHGRO BINDII KILLER FOR BUFFALO LAWNS	A RICHARDS PTY LTD T/A RICHGRO GARDEN PRODUCTS	EC
YATES BINDII & BROADLEAF LAWN WEED SPRAY	ORICA AUSTRALIA PTY LTD	EC
YATES KILLS WEEDS LUSH BINDII & BROADLEAF WEEDER	YATES AUSTRALIA A DIV OF ORICA AUSTRALIA PTY LTD	EC
YATES SELECTIVE ZERO BINDII & BROADLEAF WEEDER	ORICA AUSTRALIA PTY LTD	EC

Previously sold as Homyx Selective

4 CHEMICAL GROUP: C, I.

2. Concentration of Active Constituent : Bromoxynil 200 g/L + MCPA 200 g/L as water miscible esters.

Combustible - Flash Point >63oC.

4. Poison Schedule : 6

8.	Dangerous Goods Class : 6.1(b), Sub class 3, Packaging group III.
9.	Shelf Life : > 24 months

(When stored under ideal conditions- refer Page 4)

10.	Mixtures Compatibility :

Avenge (difenzoquat) Hoegrass/Nugrass (diclofop-methyl)

dicamba Le Mat (omethoate)

Achieve (tralkoxydim) MCPA

When mixed with diclofop-methyl and Achieve do NOT exceed 1.4 L/ha.

11.	Registered Crop(s) : Wheat, Barley, Oats, Linseed, Cereal Rye, Triticale.
12.	Effect of Soil Texture on Herbicide : No effect unless plant growth is affected.
13.	Effect of Soil pH on Herbicide : No effect unless plant growth is affected.
14.	Effect of Soil Organic Matter on Herbicide : No effect unless plant growth affected.
15.	Mode of Action : Foliage translocated, some contact, Post-emergent.
16.	Application Timing : Cereals - 3 leaf to fully tillered [1.0 - 1.4L/ha], 5 leaf to fully tillered [2.0 L/ha]. Linseed - 5 to 15 cm high
17.	Rate Variations : 1.0 to 2.1 L/ha.
18.	Rates Selection : Lower rate 1.4 L/ha, higher rate 2.1 L/ha.
19.	Weeds Controlled : Tolerates 2.1 L/ha.
20.	Effect on Crop : In the early stages following spraying, temporary wilting of the crop and pasture may occur. Crop scorch may occur, particularly on oats, if treatment is delayed to later growth stages.

21a. Effect on Clover Species : Uses are limited on clover. Do NOT apply to crops or pastures undersown with lucerne, clover or medics unless damage is acceptable.

21b. Effect on Medic Species : Severe and unacceptable damage to medics.

22.	Soil Moisture at Application :

DRY - Do not spray.

MOIST - Preferred.

WATERLOGGED - Do not spray.

23.	Frost Effects : Preceding application extended frost affects weed growth and vigour and therefore results. During and after application some effect.
24.	Frost Free Days Required After Application : 5 days.
25.	Effect of Application Water Quality on Herbicide :

Saline Water - Drinkable water recommended.

Soil Colloids - Drinkable water recommended.

26.	Recommended Water Volume : 60 - 220 L/ha cereals, minimum 220 L/ha Linseed
27.	Nozzle Type : Flat fan (11002 - 11003 or equivalent). Best results with fine droplets.
28.	Recommended Nozzle Pressure : 280 kPa (40.6 psi).
30.	Recommended Wetter : Not recommended except with diclofop-methyl.
31.	Other Additives : No.
32.	Rain Fastness : 4 hours.
33.	Time Interval Before Effect is Noticed : 10 days.
35.	Effect of Herbicide/Disease Interaction on Crop :
36.	Withholding Period : Do not graze or cut for stock food within 14 days of application.
37.	Plant-Back Period : All crops approximately 2 weeks.
38.	Spray Tank Clean-Up : Wash with water and detergent then rinse three times.

Numbered data from "Crop Herbicide Information"

courtesy of A.J. Chambers, Vic. Dept of Food & Agric.

33 REFERENCES:

Acknowledgments:

Collated by HerbiGuide. For more information see www.herbiguide.com.au or phone 08 98444064.